FLAVIA Creation 150 TM - Preparing a Beverage;Drink; Brewing Beverages

8
PREPARING A BEVERAGE/DRINK
5.
When brewing is complete,
the indicator lights will
flash in an arrow pattern
to indicate that the used
freshpack should be removed.
CAUTION:
• Do not open the Pack Door, attempt to remove the pack or press drink selection buttons
before brewing is complete, this will interrupt the brewing process.
• Pressing the drink selection button during brewing will interrupt the brewing process. The
BrewerwillNOTcompleteaninterruptedbrew.
• Take care when removing the freshpackafteraninteruptedbrewasitwillbeHOT,andmay
dripHOTwater.
• Do not remove the Cold Tank from the product during brewing as this will reduce the
volume of the drink and subsequent drinks brewed.
Aftereachvend,theboilerwillheatwateruptheoptimumtemperatureforthenextdrinktobe
brewed.DuringthistimethealltheIndicatorlightswillashslowly.Theremaybeashortdelay
beforethenextbeveragecanbebrewed.WhentheBrewerisreadyalltheindicatorlightswillbe
on steadily.
Note: Always
useGripRingto
operate Pack Door
4.
Press the drink
selection button
of your chosen
freshpack.
6.
TurntheGripRinganti-clockwisetoopenthe
Pack Door and remove the used freshpack for
disposal.
Take care when removing the pack
immediately after the brewing process as it
will be HOT.
1.
OpenthePackDoorby
turningtheGripRinganti-
clockwise and insert your
chosen freshpack.
2.
Close Pack Door by turning the
GripRingclockwise.Pleasenote
that some resistance may be felt
as the Pack Door is closed. This is
normal;thisstepis“piercing”the
pack seal.
3.
Place a cup
centrally on the
CupStandand
push back until
it touches the
backstop.
BREWING BEVERAGES