FLAVIA Creation 150 TM - Installation of Your Flavia Brewer; Electrical Supply Requirements

INSTALLATION OF YOUR FLAVIA
®
BREWER
BREWER DIMENSIONS
Height – 14.4” (365mm) Width – 9.1” (231mm) Depth – 13.5” (344mm)
ELECTRICAL SUPPLY
Itisimportantthatyouhaveapowersupplyreadysothatwecaninstallyournewsystemquickly
and eciently.
Youwillneedtosupplyasuitablyratedandprotected(i.e.viaRCDand/orMCB)incomingsupply.
TheBrewermustbeconnectedtothesupplyviaanearthedwallsocket,ideallyincorporatinga
switch.
PleaserefertotheratinglabelontheBrewerfordetailsofthesupplyvoltage,frequencyand
powerratingrequiredtooperatetheBrewer.
Useonlyonesystempersocketandensureitisearthed.
Yoursystemcomessuppliedwithamainslead,69”(1.75m)inlength.Onlythisleadshouldbe
used, no old leads should be re-used.
Donotuseextensioncables;plugsuppliedmainsleaddirectlyintosocket.
3
Note: Ifyouareunsureaboutanyinstallationrequirements,consultanelectrician.