FLAVIA Creation 150 TM - Troubleshooting

14
TROUBLE SHOOTING
ThesophisticateddesignofyourFLAVIA®BrewermakesitunlikelythatyourBrewerwilldevelopafault.
However,ifyouarehavingtroubleusingyourBrewerpleaserefertothetablebelowforadviceonhow
toresolveproblemsforyourself.Ifyourproblemisnotlistedbelowpleasecontactcustomerservice.
The Brewer does not operate.
The 5 Indicator Lights flash quickly.
The ‘HOT CHOCOLATE’ and ‘HOT WATER’
Indicator Lights flash quickly in unison.
The Brewer will not enter the priming mode.
The ‘HOT WATER’ indicator light is on
steadily and the machine is not making any
noise.
The 5 Indicator Lights flash slowly.
The Brewer does not brew beverages after
pressing selection button.
The Brewer does not deliver hot water after
pressing and holding ‘HOT WATER’ button.
None of the Indicator Lights are illuminated.
The REGULAR and OVER ICE buttons
flash in an alternating pattern with the
CAPPUCINNO/LATTE button.
Check that the Plug is correctly inserted in to
the socket.
CheckthatthePowerSwitchisintheON
position.
CheckthattheColdTankiscorrectlytted
tothemachineand/orlledtothe“MAX”
indication line.
TheBrewerhasnotbeenprimed.
TheBrewermustbeprimedwithwater
beforeusingitforthersttime.
PrimetheBrewerbyfollowingthe
instructionsonpage6.
DONOTswitchtheBreweroduring
priming.Iftheprimecycleisnotcompleted
fully it must be re-started.
Ensure there is no pack inserted and that the
Pack Door is fully closed.
Followtheinstructionscarefullyonpage6to
enter the priming mode.
The priming or flush cycle has been paused.
Pressthe‘HOTWATER’buttontoresumethe
priming cycle.
TheBrewerisheatingthewatertothe
optimumtemperatureforbrewing;thismay
takeupto90seconds.
Ensure that the pack in inserted fully and that
the Pack Door is fully closed.
Ensure there is no pack inserted and that the
Pack Door is fully closed.
Check that the Plug is correctly inserted in to
thesocketandthatthePowerSwitchisinthe
ONposition.
IftheBrewerhasseennoactivityfor120
minutesitwillenter‘PowerSave’mode.
To‘wake’theBrewerpressanySelection
ButtonoropenthePackDoor.
This is indicates that a pack inserted into the
Brewermustberemoved.Removethepack
tocontinueusingtheBrewer.
PROBLEM SOLUTION