Flex L 3709-115 Original Operating Instructions

L 10-10 125, L 810, L 1001
20
Operating instructions
WARNING!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Before switching on the power tool
Unpack the angle grinder and check that
there are no missing or damaged parts.
Switching on and off
Brief operation without engaged
switch rocker:
 Push the switch rocker forwards and
hold in position.
 To switch off the power tool, release
the switch rocker.
Continuous operation with engaged
switch rocker:
 Push the switch rocker forwards (1.) and
engage by pressing the front end (2.).
 To switch off the power tool, release
the switch rocker by pressing the rear
end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Quick-release guard
WARNING!
When using the angle grinder for roughing
or cutting, never work without the guard.
 Pull out the mains plug.
 Loosen the clamping lever (a).
 Adjust the guard.
 Tighten screw (b) until the clamping lever
can just be clamped by hand.
 Retighten the clamping lever.
 A special quick-release cutting guard
must be used for cutting.

Flex L 3709-115 Specifications

General

Brand	Flex
Model	L 3709-115
Category	Grinder
Language	English