10
CONTROL DIRECTION TEST
Refer to the chart at right to determine the proper control
surface direction. Reversed controls may be corrected in
either the transmitter’s servo reverse menu or through the
Aura 8 app in the outputs section.
After any adjustments, repeat the ight control sensing
direction test, and the control direction test to conrm
that all control surfaces respond according to the correct
corresponding stick movement.
AILERONRUDDER ELEVATOR
Transmitter
Command
Proper Control
Surface Deection
Stick Left
Stick Right
Stick Forward
Stick Aft
Stick Left
Stick Right
LINKAGE SETUP
Adjust the control linkages so that the surfaces are neutral with zero trim and zero subtrim. Adjustments may be required during ight
trimming − for more information, please refer to the trimming section located on page 13 of this manual.
At the servo, the stock linkage attachment is a Z-bend located in the outermost hole in the servo arm for the rudder, the second hole in
from the outside for the elevator, and the third hole in from the outside for the ailerons.
At the control horn, the stock attachment is a nylon clevis located in the outermost hole for aileron, and innermost hole for rudder/elevator.
SERVO ARMS
AILERONSELEVATOR
RUDDER
CONTROL HORNS
AILERONSRUDDER/ELEVATOR
To Next Page
Loading...