4
MAIN LANDING GEAR INSTALLATION
Required Tools and Fasteners: #1 Phillips Screwdriver, (4) M1.5x5 self-tapping screws
1. Insert the landing gear assembly into the slot in the bottom of the fuselage. The gear will sweep forward.
2. Install the cover plate over the landing gear slot and attach with (4) M1.5x5mm self-tapping screws.
TAILWHEEL INSTALLATION
Required Tools and Fasteners: #1 Phillips Screwdriver, (3) M1.5x5 self-tapping screws
1. Insert the tailwheel assembly in the slot in the bottom of the rudder.
2. Install the cover plate over the tailwheel slot and attach with (3) M1.5x5mm self-tapping screws.
To Next Page
Loading...