5
HORIZONTAL STABILIZER INSTALLATION
Required Tools and Fasteners: Clear Tape (4 strips)
1. Insert the horizontal stabilizer tube into the fuselage and roughly center.
2. Slide the left and right stabilizer halves onto the tube. Ensure that the control horn orients towards the belly of the airplane and that the
elevator joiner tabs are properly indexed. Do not force the stabilizer into place.
3. Apply 4 pieces of clear tape to the joint between the stabilizer and the plastic mounts. Be sure to apply tape to both the top and bottom.
4. Attach the clevis to the elevator control horn in the innermost hole. Slide the clear tubing over the forks.
TOP AND BOTTOM
To Next Page
Loading...