Flex TRINOXFLEX BME 18.0-EC + LK 152 - Attachment Mounting and Removal; Mounting Attachments; Removing Attachments

TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
33
Mounting attachments
 Place the required attachment on a level
work surface with the quick-release cou-
pling facing upwards.
 Place the drive unit in the required position
for the attachment and press down until it
engages audibly (1.).
 Close the clamping lever (2.).
 Open the clamping lever on the attach-
ment (1.).
 Place the drive unit in the required position
for the attachment and press down until it
engages audibly (2.).
 Close the clamping lever (3.).
NOTE
If the attachment does not audibly engages,
move the spindle or drive pully of the tool a
bit, so that the coupling can interlock.
 Loosen the locking screw (1.).
 Place the drive unit on the quick-release
coupling (2.).
 Re-tighten the locking screw (3.).
Removal of attachments