Flex TRINOXFLEX BME 18.0-EC + LK 152 User Manual

TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
37
Work instructions for the pipe belt sand-
ing attachment
CAUTION!
When it is switched off, the sanding tool
continues to run briefly.
Compared with a sanding/grinding disc, the
advantages of a belt sander are as follows:
– Cool sanding
– Clean finish without scoring
– High abrading performance
–
High productivity owing to large angle of
contact (depending on diameter)
Sanding/grinding:
NOTE
After bringing into contact with the work -
piece and before switching on the machine,
check that the belt is in complete contact
with the rollers.
– Pipes are sanded between rollers 31
and 33.
– The angle of contact and the abrading
performance can be varied by the amount
of pressure applied.
– The smaller the pipe diameter, the greater
the possible angle of contact. An angle of
up to 270° is possible.
Sealing:
Many manufacturers recommended sealing
finished surfaces with a protective spray
(see Flex stainless steel accessories).
For further information on the manufactur-
er’s products go to www.flex-tools.com
.
Belt file sanding attachment BF 140
WARNING!
Remove the battery before carrying out any
work on the power tool.
Fitting or changing the sanding belt
 Remove the battery.
 Remove the handle ( 1. ) .
 Swivel the housing cover to one side (2.).
 Turn the eccentric screw and in doing so
detension the sanding belt (3.).
 Remove the sanding belt (4.) (optional).
 Fit a new sanding band centrally on the
sanding arm (5.).
 Tension the sanding belt by turning the ec-
centric screw.
 Fold the housing cover back onto the
housing.
CAUTION!
Observe the prescribed direction of belt
rotation! The direction of rotation must
correspond with the arrow on the gear head.

Flex TRINOXFLEX BME 18.0-EC + LK 152 Specifications

General

Battery Voltage	18 V
Spindle Thread	M 14
Type	Angle Grinder
No Load Speed	3500-8500 rpm
No-load speed	3500-8500 rpm