Flex TS 92 18-EC - Noise and Vibration; Technical Data

33
TS 92 18-EC
󰀲
Never stand on the table saw, do not use
it as a stepping stool. Serious injury could
occur if the tool is tipped or if the cutting
tool is accidentally contacted.
󰀲
Make sure that the saw blade is installed
to rotate in the proper direction. Do not
use grinding wheels, wire brushes, or
abrasive wheels on a table saw. Improper
saw blade installation or use of accessories
not recommended may cause serious
injury.
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 62841-3-1.
The A evaluated noise level of the power tool
is typically:
–
Sound pressure level L
pA
: 91 dB(A);
–
Sound power level L
WA
: 100 dB(A);
–
Uncertainty: K = 3 dB.
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardised in EN 62841-3-1 and may be
used to compare one tool with another.
That the declared vibration total value(s) and
the declared noise emission value(s) may
also be used in a preliminary assessment of
exposure.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the vibration
exposure level, it is also necessary to take into
account the times when the tool is switched off
or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration
such as: maintain the tool and the cutting
accessories, keep the hands warm, organisation
of work patterns.
WARNING!
that the vibration and noise emissions
during actual use of the power tool can
differ from the declared values depending
on the ways in which the tool is used
especially what kind of workpiece is
processed; and
of the need to identify safety measures
to protect the operator that are based on
an estimation of exposure in the actual
conditions of use(taking account of all
parts of the operating cycle such as the
times when the tool is switched off and
when it is running idle in addition to the
trigger time).
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
Technical data
Tool TS 92 18-EC
Type Table Saw
Rated voltage V 18
No load
speed
/min 5000
variable
speed
/min 2000-5000
Blade size mm 254
Hole diameter mm 30
Max. bevel
angle
° 47
Max. cutting
depth - 45°
bevel
mm 58
Max. cutting
depth - 90°
bevel
mm 92
Max. rip
capacity on
the right side
of the blade
mm 780