Flexologic FAMM - Liability; Contact Information; Tools List; Starting the Machine

3
H. Kamerlingh Onnesweg 2
2408 AW Alphen aan den Rijn
The Netherlands
CONFIDENTIAL - THIS DOCUMENT MAY NOT BE DISCLOSED TO ANY THIRD PARTY OR USED FOR ANY
OTHER PURPOSE WITHOUT THE EXPRESS WRITTEN PERMISSION OF AV FLEXOLOGIC BV
CONFIDENTIAL
3. Liability
AV Flexologic BV is not accountable for injuries sustained from using the FAMM, if personnel is not
properly schooled, if steps in this manual were not followed in detail, if incorrect tooling was used, or if
proper personal protective equipment was not used.
4. Contact information
If there are any questions or obscurities during the use of this manual and there is no
means of continuing, please contact the service department of AV Flexologic at Support@AVflexologic.com
5. Tools list
The following tools are required to operate the FAMM. Please make sure the tools are available before
starting. If these tools are not available, please do not use the FAMM.
#
Description
Qty
1
NONE
2
3
NOTE: Images are indicative, colours and/or shapes may vary.
6. Starting the machine
This section describes the power-up of the FAMM.
Step
Action
1
Make sure the machine has been powered down for at least 5 minutes.
2
Make sure the emergency stop button(s) are not activated (See section 7)
3
Turn the main power switch located on the front of the machine to the “ON” position:
4
Wait for the system to power up.
5
Enter username: Operator
Enter password: avmom
6
Wait for the software to completely boot up.
A
B
I : POWER ON POSITION (A)
O : POWER OFF POSITION (B)