Page 8 © 2017 FlexRadio Systems, v1.0.0
Remove the MicroSD Card
The next step is to remove the MicroSD card from the FLEX-6000.
The MicroSD card is located adjacent to the FPGA processor/fan assembly. There may be a piece of
Kapton tape covering the top of the card retaining clip. If so, carefully remove the Kapton tape.
Gently slide the silver MicroSD card retaining clip away from the FPGA processor/fan assembly so that it
releases and lifts up as shown below.
Using a non-metallic object to lift up on the end of the card nearest to the FPGA processor/fan assembly,
the MicroSD card should easily lift out of the card socket so it can be removed.
To Next Page
Loading...
