Page 7 of 73
Copyright 2023 FlexRadio. All Rights Reserved. 4 January 2023 (FW:3.7.28 Utility:3.7.28)
2.2 Back Panel
The back-panel connectors are logically divided into two groups, the A port connectors, and the B port
connectors. The amplifier will amplify the signal on the A input and output it on the A output, or it will amplify
the signal on the B input and output it on the B output. The A and B sections of the amplifier can be controlled
independently by two radios. Separate A and B keying inputs (Push-To-Talk, PTT) and band data inputs are
provided. At any point in time either of the A or B sections can be keyed, but they cannot be keyed
simultaneously.
Please refer to the table below.
To Next Page
Loading...