EasyManua.ls Logo

flexvision AVT-1498 - Troubleshooting Common Issues

flexvision AVT-1498
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
–27–
TROUBLESHOOTING
SYMPTOM CAUSE POSSIBLE SOLUTION
No Power No 12 volt DC power to the *Check circuit fuse at source of
set power (see vehicle owners
manual)
Be sure TV switch in
overhead switch panel is on
Indicator light on front of Power cord is not plugged *Check that power cord is plugged
set is not on into DC outlet into jack of TV
DC power plug is not *Check in-line fuse of power cord
inserted into the jack on to set either on red wire or in
the TV lighter plug
*Check fuse in TV (20 x 5 mm
5 amp)
*Check (unplug power cord) and
test for 12 VDC positive and
ground at coaxial DC plug
*Turn on overhead switch panel
(if applicable) may control power
to TV