OPTIONAL ACCESSORIES
WIRELESS HEADPHONES
The LCM1502TV includes a 49MHz RF Transmitter for use with Flexvision Wireless Headphones (P/N WHPRF01). Turning the
Headphone switch ON will activate the internal RF Receiver, the volume can then be adjusted using the controls on each headset.
Use the adjustment knob on the headset to fine tune the Headphones to the proper frequency. Any number of wireless headphones
can be used.
Consult the documentation accompanying the Flexvision Wireless Headphones for more information.
The LCM1502TV also includes a built in Infrared Transmitter for use with Audiovox Wireless headphones (P/N MVIRHS). Turning
the Headphone switch ON will activate the internal IR Receiver, the volume can then be adjusted using the controls on each
headset. Any number of wireless headphones can e used, but all must be within a line of sight from the transmitter, as infrared
transmissions, like visible light travel only in a straight line.
NOTE: AUDIOVOX Wireless Headphones (P/N MVIRHS) are for use with the “A” channel only. If both A and B channels are used,
AUDIOVOX Headphones (P/N IR2CHS) will be required.
WIRED FM MODULATOR (P/N FMT100)
Your video system may be equipped with an optional RF modulator, that allows you to listen to the LCM1502TV’s audio signal by
tuning your vehicle’s radio to the selected frequency, (88.7 or 89.1- check with your installer) and tuning on the remote mounted RF
modulator switch. (In most cases this toggle switch will be located underneath the driver’s side of the dash, check with your installer
for the exact location.) Whenever the RF Modulator is ON, broadcast radio reception will be poor. Turning the remote mounted
toggle switch OFF will allow for normal radio reception.
26
To Next Page
Loading...
Need help?
General