Page 12
7 SPECIFICATIONS
General
b. Frequency range : 118.00 to 136.975MHz (Receive:108.00 to
136.975MHz)
c. Channel spacing : 25kHz
d. Mode : AM (6K00A3E)
e. Number of memory channels : 99
f. Acceptable power supply : 10.5 V to 33 VDC (Negative ground only)
g. Usable temp. range : -20℃ to +60℃
h. Frequency stability :+/- 5ppm
i. Current drain : TX: 3A(max) RX 0.8A(max) Standby:
300mA
j. Dimensions : W61 X D159 X H61 (mm)
k. Weight : 430g
l. Exposed dial face : 56.4mm 2
1/4.5 inches
Transmitter
m. Output power : 5 W (carrier), 16W (pep)
n. Modulation : Final stage modulation
o. Modulation limiting : 70 to 100%
p. Audio harmonics distortion : Less than 15% (at 85% modulation)
q. Hum and noise ratio : More than 40dB
r. Spurious emissions : -16dBm or less
s. Antenna impedance : 50Ω
Receiver
t. Receive system : Double conversion superheterodyne
u. Intermediate frequency : 1st : 50.85MHz (Upper) 2nd : 450kHz
(Lower)
v. Sensitivity (at 6dB S/N) : Less than 1uV
w. Squelch sensitivity : 0.5uV (Threshold)
x. Selectivity : More than ±3kHz (at 6dB)
: Less than ±25kHz (at 60dB)
y. Spurious response rejection : More than 60dB
z. Audio output power : More than 4W (at 4Ω)
aa. Side tone : More than 100mW (at 600Ω)
bb. Hum and noise : More than 30dB
cc. Audio output impedance : Ext. SP 4Ω (4 to 8Ω)
Side tone 600Ω
Accessories
dd. D-SUB-15 connector (female) and cover X 1
ee. Screw for mount (6-32) X 4
ff. Installation/Operations Manual X 1
To Next Page
Loading...