Page 3
1 INTRODUCTION
Thank you for purchasing this quality product from Flightline.
This transceiver has been designed and manufactured in Japan specifically for Ultralights,
Gliders and General Aviation Aircraft and Helicopters with size and power consumption as the
main considerations. Ease of operation was another primary achievement.
Please follow this manual closely to ensure optimum performance, we do hope you have many
hours of trouble free communication and safe flying.
2 INSTALLATION INSTRUCTIONS
This manual contains all of the necessary instructions for installation and operation. After
installation please keep this manual in a safe place for future reference.
3 INSTALLATION CONSIDERATIONS
As with all aircraft radios, successful communications start with the installation. After unpacking
the transceiver verify all parts against the parts list. Select a suitable mounting area within a
maximum 30 degree viewing angle and select a suitable location for operation of ancillary controls,
backlight, intercom etc.
The use of aviation quality shielded cable is recommended at all times.
Avoid running or wrapping other wires around the antenna lead and keep lengths as short as
reasonably possible. Ensure that the radio is not exposed to direct rain or moisture (we do not
accept liability for water damage).
Make sure the transceiver is connected to a 10.5-16.8 volt or 23-33 volt battery system.
Do not use AC volts from a Rotax lighting coil.
To Next Page
Loading...