2. Operation (Restoration & Discharge)
PROGRAM MODE – SETTING ( V = Voltage, A = Ampere, T = Time )
Operation Screen : Click “Program “
on top menus
Program Mode – Setting Screen
Operation will proceed automatically
according to the set modes in order.
Total 5 modes are supported and total
Set
ting time is 99H:59M.
Pulse has six(6) patterns for restoration and
tw
o(2) patterns for Discharge in Program
Mode.
MODE : Restoration, Discharge, Pulse patterns, Set V, Set A, Set T per each Mode.
MODE ON / OFF : Activate or Skip depend on your selection
As you can see on the screen,
O
per
ator can perform Restoration and Discharge as per his scenarios of Mode..
[program setting screen]
You should check specification & conditions of used batteries before you input Set V,
Set A and Set Time for regeneration of batteries. Wrong set values will cause damages to
batteries due to over charge or other reasons.
40
To Next Page
Loading...