The FLIR CM174 Imaging 600A AC/DC Clamp Meter with IGM is the
first clamp meter equipped with a built-in thermal imager that can
quickly lead you to problems you can’t see with a standard clamp
meter. Featuring Infrared Guided Measurement (IGM) technology,
the CM174 visually guides you to the precise location of a potential
electrical problem, identifying dangerous and unknown problem areas
safely. Confirm your findings with accurate amperage and voltage
measurements, and center-point temperature readings. The narrow
jaw enables greater accessibility, and its compact form-factor fits
easily into your back pocket – so you can have thermal imaging at your
fingertips everywhere you go. The FLIR CM174 will quickly become
your primary electrical troubleshooting tool.
Find problems faster with IGM.
Visually identify electrical issues with the
first thermal imaging clamp meter
• Conquer cluttered wires and cables – IGM can quickly guide you in
the right direction
• All-in-one tool – carry just one device and always have access to
thermal imaging
• Work safely – scan a panel or cabinet for hazards using IGM without
direct contact
Confirm your findings.
Verify problems, check load, and validate hot spots
• Center-point temperature to confirm hot spot
• Amperage and voltage measurements to check the load
• Laser and crosshair pinpoint the location of the problem found in
thermal image
Solve complex electrical issues.
Design and functionality vital to professionals
• Narrow jaw and built-in worklights help you access difficult locations
with lighting issues
• Advanced electrical features: True RMS, LoZ, VFD Mode, Inrush,
Smart Diode with Disable
• Expandable to 3000 Amps AC with FLIR flex accessories
IGM technology guides you where to measure
Verify amperage measurements
FLIR CM174
Imaging 600A AC/DC Clamp Meter with IGM™
Part Number: 94-CM174
Flight Systems
Industrial Products
1-800-333-1194 • www.batteryrestoration.biz
To Next Page
Need help?
General
