5 Operation
5.15.2 Procedure
1. Pair the IR camera with the instrument. Refer to the camera manual for infor-
mation on how to pair Bluetooth devices.
2. Turn on the camera.
3. Turn on the meter.
4. Press the
on the meter to enable Bluetooth.
5. Choose the variable that you want to use (voltage, current, resistance, etc.).
Results from the meter will now automatically be displayed in the result table
in the top left corner of the IR camera screen.
Note
The meter’s internal update rate is faster than that of the Bluetooth data trans-
mission rate; therefore, values displayed on the remote device may differ
slightly from the values displayed on the meter.
#T559826; r. AD/ 9130/9130; en-US 22
To Next Page
Loading...