427-0030-00-12 Version 170 Mar 2014 2-23
2 Basic Operation and Configuration
After the camera boots up, confirm the startup information is displayed on the analog monitor after
approximately 90 seconds. For example:
S/N: 1234567
IP Addr: 192.168.250.116
PelcoD (Addr:1): 9600 SW
2.11 Setting the IP address on a Windows PC
To set the computer IP address in Windows, first connect the PC to a switch, or connect it to the
camera and ensure the camera has power.
Step 1 With the PC or laptop connected to the switch (or if back-to-back with the camera, with the
camera powered on), open the Control Panel, Network and Sharing Center (a Windows 7
example is shown). The connection to the camera should show in your Active Networks.
To Next Page
Loading...
