FLIR K2

Operation
10
10.1 Charging the battery
10.1.1 Charging the battery using the FLIR power supply
Follow this procedure:
1. Connect the power supply to a wall outlet.
2. Connect the power supply cable to the USB connector on the camera. To access the
USB connector, see section 10.3 Accessing the connector bay, page 18.
Note The charging time for a fully depleted battery is 2 hours.
10.1.2 Charging the battery using the FLIR stand-alone battery charger.
Follow this procedure:
1. Connect the stand-alone battery charger to a wall outlet.
2. Remove the battery from the camera.
3. Put the battery into the stand-alone battery charger.
Note
• The charging time for a fully depleted battery is 2 hours.
• The battery is being charged when the blue LED is flashing.
• The battery is fully charged when the blue LED is continuous.
#T559972; r. AG/39882/39882; en-US
17