FLIR K65 - Procedure (FLIR K65)

Operation
12
12.10.2 Procedure (FLIR K65)
Follow this procedure:
1. Fold up the rubber cover at the top of the camera.
2. Fold up the metal ring.
3. Unscrew the Torx T20 screw.
CAUTION
Make sure that you do not use a torque value that is more than 80 Ncm on the Torx T20 screw.
Damage to the camera can occur if you do not obey this.
4. Pull out the plastic insert.
CAUTION
The plastic insert has an O-ring seal. Do not damage the O-ring seal.
#T559946; r. BG/87484/87484; en-US
31