JCU SETUP
Go back to “My Network Places” or “Network” and double click on the JCU icon to open its
configuration page.
Set the Network Addressing to “Static”:
Enter the appropriate IP address and subnet mask (192.168.252.201 / 255.255.255.0) and click on
the “Save”.
FINAL SETUP
After changing the IP address of the M-Series Camera and JCU, change the IP address of the PC
(192.168.252.10 / 255.255.255.0) to confirm that you see the FLIR and JCU icon again in “My
Network Place” (XP) or “Network” (Vista/Windows 7,8).
Note: You may need to restart the Camera and JCU for the Icon to appear in “My Network Place”.
TZtouch Configuration
Press the [HOME] key, the [MENU] button and select [Camera]. Press [Scan] under “FLIR
Installation”:
To Next Page
Loading...
