Quick Start
INTRODUCTION
The latest versions of the detailed User Manual and Quick Start,
with translations, are located on the http://support.flir.com web site
(download tab). Please read these documents carefully before use.
QUICK STEPS
1. Ensure that two fresh 1.5V ‘AA’ batteries are installed in the me-
ter’s rear compartment.
2. Long press the Power button
to switch the meter ON. The
meter automatically switches OFF after 20 minutes (APO).
3. Short press the button to select a material group 1~11 (see
Measurement Considerations section).
4. Remove the protective cap and firmly insert the test pins into
the material under test.
5. Read the moisture level in % on the meter’s large display digits.
6. Read the ambient temperature or relative humidity on the small-
er digits. Long press the
button to select ℉, ℃, or RH
display.
7. Long press the
button to switch the meter’s backlight ON/
OFF. Short press the
button to switch the meter’s worklight
ON/OFF.
8. To freeze/unfreeze a displayed measurement, short press the
HOLD button.
9. To transmit a held reading, refer to the Bluetooth section below.
10. Replace the protective cap after each and use caution when the
sharp pins are exposed.
11. Verify calibration using the test points in the protective cap as
described in the User Manual.
#NAS100098; r. AB/80702/80849; en-US
1
To Next Page
Loading...
Need help?
General
