Quick Start
INTRODUCTION
To obtain the detailed User Manual please visit http://support.flir.
com (download tab). Please read the user manual carefully before
use. The MR59 includes a 3-year limited warranty, visit www.flir.
com/testwarranty to read the warranty document and to register
your product.
QUICK STEPS
1. Ensure that a 9V battery is installed in the meter’s rear
compartment.
2. Long press the power button
to switch the meter ON. The
meter will display ‘CAL’ while it performs a ZERO calibration
(keep hands and objects away from sensor during this
calibration).
3. The meter automatically switches OFF after 30 minutes (APO).
4. Place the ball sensor on the surface of the material under test.
The sensitivity of the sensor is uniform across its entire surface.
The sensor can detect moisture to a depth of 4 in (100 mm)
maximum.
5. Read the moisture level in % on the meter display. Take read-
ings in several locations for the best representation of the mois-
ture present.
6. Note the MAX and MIN moisture readings on the display. Long
press the CLEAR button to reset the MAX/MIN readings.
7. Long press the
button to switch the meter’s backlight ON/
OFF.
8. Long press the
button to switch the meter’s Work Light ON/
OFF.
9. To freeze/unfreeze a displayed reading, short press the HOLD
button.
10. The MR59 beeps when the moisture reading exceeds the high
alarm limit. To set the alarm limit, short press the SET button,
and then use the up /down arrows to set the value (press SET
again to exit). To enable/disable the alarm, long press the SET
button. When the alarm is enabled (default), the alarm bell icon
appears.
11. Refer to the Bluetooth section below, and the separate user
manual, for information on transmitting readings to a remote
device.
#NAS100096; r. AB/80574/80853; en-US
1
To Next Page
Loading...
Need help?
General
