910-0001-00-MAN-R06 FLIR Proprietary Information Page 25 of 81
Information contained in this document pertains to a Canadian origin product that is controlled as "dual use" by the Canadian
government. However, when in the United States or possessed by a US person, it may be considered a defense article from the US Government's
perspective. US government authorization may be required for re-transfer to a foreign person. If you have any questions, please contact FLIR's
Global Trade Compliance group at exportquestions@flir.com .
2.2.4 Regular Scan Mode Change (applies only to R4SS-X, R6SS-X, R8SS-X and R20SS radars)
When equipped with a pan/tilt positioner, the R4SS-X, R6SS-X, R8SS-X and R20SS supports 3 different
regular scan modes: fixed, continuous and alternating. In order to access those modes, the radar must
first be configured to activate the pan/tilt positioner. The parameter that enables the pan/tilt
positioner is called "Moving_base_config" (see Figure 11). Please refer to section 2.2.10 for instructions
on how to modify a configuration parameter.
Figure 11 - Pan/Tilt Positioner Enable Parameter
To Next Page
Loading...
Need help?
General
