This document does not contain any export-controlled information.
Installation
11
427-0200-00-12 - Revision 110 - May 2021
Place the sponge inside the
bracket and route the cables
through the center of it, as
shown. You might need to cut a
slit in the sponge.
Route the cables through the
bracket.
Follow camera instructions to
assemble the pendant cap.
Use the Allen key and a hex
head cap screw to assemble and
firmly affix the camera's pendant
cap to the bracket.
Affix the power box to the wall or
to the column.
Attach the bracket to the power
box.
Buckle up the safety rope, make
the camera connections, tighten
the two hex screws to seal the
box, and then complete
assembly.
To Next Page
Loading...
