This document does not contain any export-controlled information.
Installation
18
427-0200-00-12 - Revision 110 - May 2021
2. Authenticate the camera.
Right-click the camera and select
Login, or click the Login icon in the
navigation bar.
In the DNA - Login window, type the
password for the admin user
(default: admin). Then, click Login.
In the DNA Discover List, verify that the camera's status is Online and Authenticated.
3. Configure the camera’s networking settings.
Right-click the camera and select IP
Setup, or click the IP Setup icon in
the navigation bar.
In the DNA - IP Setup window, you
can clear Use DHCP and manually
specify the camera's IP address,
Mask, and Gateway.
Then, click Update and wait for
Ok status to appear.
To Next Page
Loading...
