FLIR Saros DM-695-S

This document does not contain any export-controlled information.
Configuration
38
427-0200-00-12 - Revision 110 - May 2021
The following settings for the device managing the external I/O connections are available:
· Enabled or Disabled
· Device IP address and port
· Input and output base addresses
You can define the number of input and output pins the device manages.
The following information appears for each pin:
· I/O pin number
· Type—Input or Output
· State—the pin's current state: Open or Closed
For each pin, you can define the following:
· Idle State—Open or Closed
· Alarm Auto Ack—Yes or No
· Enabled—Yes or No
· Reset Interval (for output pins only)—between 0-600 seconds; specifying 0 seconds disables the
auto reset
Related Operation and Configuration Information
For information about changing the current state of the input and output pins, see I/O Page.
For more information about how to configure the device managing the external I/O connections, refer to
the device's documentation.