FLIR TG54 - Programming High and Low Alarms; Configuring Laser Pointer; Setting Temperature Units (°C;°F)


FLIRTG54_TG56UserManual19DocumentIdentifier:TG54_TG56‐en‐US_AA
6.2.3ProgrammingHighandLowAlarms
Setthealarmsoff(greycircularicon),setonlyaHigh(red)orLow(blue)alarm,orsetbotha
HighandaLow(redandblue)alarm.
1. PressandholdMenutoaccesstheProgrammingmenuandscrolltotheAlarmicon
.
2. PressMenutoopentheitemanduseMenuagaintoselectOFF
,High ,Low ,
orHigh/Low .
3. IfOFF

isselected,press
toreturntotheProgrammingmenu.
4. Forallotherselections,scrolldowntothealarmthresholdfieldandsettheHigh,Low,or
HighandLow(combination)alarmsetpoints.Forexample,ifLowalarmisselected:
a) UsethearrowbuttontoscrolldowntothealarmthresholddigitsandpressMenu.
b) UsethearrowbuttonstoselectthedesiredLowalarmthreshold.
c) PressMenutoconfirmandpress
toreturntotheProgrammingmenu
5. Followthestepsabovetoprogramtheotheralarmmodes.NotethattheHighalarm
thresholdcannotbesetlowerthantheLowalarmthresholdandviceversa.
6. RefertoSection5,Operation,formoreinformationonAlarmoperation.
6.2.4SettingtheLaserPointerONorOFF
1. PressandholdMenuandusethearrowbuttonstoscrolltotheLaserPointer icon.
2. UsetheMenubuttontotogglethelaserpointerON/OFF.
3. Whenselectioniscomplete,usethearrowbuttonstoscrolltoanothermenuitemor
press
toreturntothenormaloperatingmode.
6.2.5SettingtheTemperatureUnits
o
C/
o
F
1. PressandholdMenuandusethearrowbuttonstoscrolltotheunitsicon .
2. UsetheMenubuttontotoggletheTemperatureunits.
3. Whenselectioniscomplete,usethearrowbuttonstoscrolltoanothermenuitemor
press
toreturntothenormaloperatingmode.