Need help?Do you have a question about the FLIR UltraFORCE 350-HD and is the answer not in the manual?
General| Resolution | 640 x 480 |
|---|---|
| Frame Rate | 30 Hz |
| Lens Options | Fixed |
| Thermal Sensitivity | <50 mK |
| Operating Temperature | -20°C to +50°C |
Details the methods and procedures for operating the UltraFORCE 350-HD system.
Covers pre-flight checks, daily inspections, and cleaning procedures for the system.
Details power-on, power-off, turret functions, and specific camera/sensor operations.
Explains the function of various hardware controls on the Hand Controller Unit (HCU).
Illustrates and describes system status indicators and symbology areas.
Details auto tracker operational modes like Standby, Correlation, and Aimpoint Refinement.
Information on the eye-safe laser module and its range measurement capabilities.
Details on Class 3B laser modules, safety precautions, and operation.
Covers IMU conditions for valid coordinates and Geo-Target mode.
Explains the system's BIT function for detecting and displaying faults.
Guidelines for system storage and factors affecting operational performance.
Provides information for diagnosing and correcting system problems down to module level.
Lists relevant technical documents for maintenance and system definition.
Describes the TCU's electro-mechanical architecture and stabilization.
Details maintenance levels for operators, technicians, and factory checks.
Lists recommended tooling and equipment for maintenance procedures.
Step-by-step procedure for purging the system with nitrogen.
Information on removing, refitting modules, and calibrating the IMU.
Table of recommended torque values for various bolt sizes during installation.
To Next Page
