FLIR UltraFORCE 350-HD - System Operation Modes

SYS11000OM Rev G
[UF 350-HD, Generic Template]
FLIR Systems Polytech AB Page 9 of 70
Antennvägen 6
SE-187 66 Täby
Sweden
1.3 UltraFORCE 350-HD Operation
1.3.1 Power-on (start-up) procedure:
 Ensure that the TCU has mechanical freedom of movement and that no
interference from surrounding objects/obstructions is present.
 Ensure that the TCU is placed in STOW position before the system is powered
on.
 Ensure that a stable DC power supply is available.
NOTE: Do not power-on the TCU during aircraft engine start-up.
 Ensure that a monitor is correctly connected and powered up.
 Power-on the system using the HCU. (see § 1.4.1)
 Perform a Joystick calibration, as described in § 1.4.7.
 Null any Azimuth and Elevation drift, as described in § 1.4.12 and 1.4.13.
NOTE: This action should be performed when the system has warmed up in order to achieve
the best result.
The system will start-up and initialize according to the conditions defined below:
NOTE: The thermal imager will need a cool down period of approx. 7 min before an
image is displayed. The TI display is showing INIT during this period (See § 1.5.6)
Avoid to power-off the TCU during the initialization phase.
Feature
Condition after initialization
Initial Position
Last CAGE setting (or STOW if STOW
switch is selected)
Joystick Sense
Push forward for negative elevation
Auto Tracker Mode
Standby
Selected Sensor
TV camera
TV FOV
Fully wide
TV E-Zoom
No Electronic Zoom selected
TV Iris & Gain
Automatic
TV Focus
Autofocus
TV Freeze
Live image
TV IR Cut off filter
In
TV White Balance
Automatic
TI FOV
Wide
TI E-Zoom
No Electronic Zoom selected
TI Level & Span
Automatic
TI Polarity
White hot
TI Freeze
Live image
TI DDE
DDE off