SYS11000OM Rev G
[UF 350-HD, Generic Template]
FLIR Systems Polytech AB Page 10 of 70
Antennvägen 6
SE-187 66 Täby
Sweden
Condition after initialization
1.3.2 Power-off (shut down) procedure:
The system can be powered off from any mode, at any time, without damaging the
system. However, avoid to power-off the system during the initialization phase.
From an operational point of view, it is highly recommended to select STOW prior to
powering off, as the STOW position is important for the protection of the optical windows
during aircraft take-off and landing.
1.3.3 Flying the TCU in an unpowered state
The TCU must be in STOW position if the system is to be flown in an unpowered state
(e.g. during ferry flight.)
NOTE: The TCU can be moved to STOW by hand if the TCU is not in the STOW position, if the
system is unpowered and prior to flight. STOW position is considered +90° lookup (to engage the
STOW magnet) and -180° from the flight path.
1.3.4 Turret Functions
Reference Section/Paragraph
1.4.4 (systems with TV and IR)
1.4.11 (systems with TV, IR and Spotter)
Set Azimuth Joystick Gain
Set Elevation Joystick Gain
Change Elevation Joystick
Sense
To Next Page
Loading...
