Flite 3 Series - Page 17

Charging Flite Controller
1 Remove Flite Controller from the accessories pouch or
Flitescooter handlebar.
2 Remove Flite Controller USB Wall Charger and Charging Cable
from the accessories pouch.
3 Carefully peel out the rubber cover on the underside of Flite
Controller. Attach the magnetic charging plug, ensuring the
charging pins are connected.
4 Plug in the USB Wall Charger and turn on. When the Flite
Controller is charging correctly, the screen will show a charging
message. Be careful not to disconnect the magnetic charging
plug whilst charging. Always check to ensure the Flite Controller
is at least 50% charged before each use.
1
3
2
4
Pg. 43 - Angle too aggressive
Updates
Pg. 12 - Update ite scooter bladder
Pg. 12 - Update ite scooter core
Pg. 27 - Update 'turning on itescooter' image
Pg. 17 - long throw trigger update
Pg. 32 - Update handlebar image to one without controller in it.
- Add existing controller image back into this page
-Add ‘Latch for Flite Controller’ to handlebar diagram
-Update line ‘throttle trigger’ to ‘Thumb throttle’
Controller as it previously was showing all controls
Add below images in this order to
Flitescooter Common Mistakes
Pg. 14 - wing and stab update - Cruiser 1800 + 500 + jet
17