Arming the motor
Flitescooter uses a safety lock to guarantee that riders cannot accidentally
spin the motor by bumping the throttle trigger unintentionally.
Riders must arm (unlock) the motor to take Flite.
1 Before arming the motor ensure you are wearing a wireless
safety key. The Flitescooter will cut o power when you are not on
the board.
2 To arm the motor, press the thumb throttle all the way in and then
release it completely.
3 Press and release the minus button.
4 Press the thumb throttle within the 5 second countdown window to
activate Flite Jet. Always verify the eFoil is clear and in a safe location
before activating the motor.
IMPORTANT: NEVER RUN THE MOTOR OUT OF WATER FOR MORE
THAN 3 SECONDS, AS DOING SO CAN OVERHEAT AND DAMAGE
THE SHAFT AND SEALS.
Connect the fuselage tail
Turning on Flitescooter
Place the inated Flitescooter
on a clear surface. Locate the
handlebar cap and remove
by gently pulling up
Turn the handlebar lock
counterclockwise so that the
opening lines
up with the handlebar cavity.
Insert the handlebars into the
handlebar cavity. Turn the
handlebar
lock clockwise until it stops.
This will keep the handlebars
locked into
place.
Flitescootering for the rst time
Arming the motor
Connect the front wing
Connect the stabliser
1
2
3
41
To Next Page
Loading...