Issue Troubleshooting guide
Flitescooter
starts to slow
or ‘limp’
This is a sign your Flitecell is about to run down
or over heat. Move out of the water and recharge your
Flitecell. Refer to the Flitecell charging instructions
(page 18).
Flitescooter
turns off
while riding
Move out of the water to a safe, dry, clean area.
Check the LED on Flitecell to confirm if it still
has charge. If it has charge, disconnect and
reconnect the Flitecell to see if you can establish
a connection. Inspect the Flitecell for water or
damage. There should be no water inside the
Flitecell housing.
Flite Controller
disconnects
Re-arm the Flite Controller.
See arming instructions (page 32).
Flite Controller
unpairs
Re-pair the Flite Controller.
See pairing instructions (page 32).
Flitecell
charger won’t
connect
Disconnect and reconnect.
Contact Flitescooter Customer Support.
fliteboard.com/support
Flite Controller
won’t turn on
Ensure Flite Controller is fully charged.
See Flite Controller charging instructions (page 17).
Flite Controller
shows a battery
or temperature
warning
Slow down or decrease power consumption to cool
the Flitecell down. The Flite Controller will warn you
when the Flitecell temperature reaches 55°C and
again at 60°C. At 65°C the Flitecell will automatically
start to shut down to preserve itself.
Troubleshooting
50
To Next Page
Loading...