Flitecell
Post ride
Wipe Flitecell down with a wet cloth (freshwater), and clean Flitecell
contacts and data connector with Contact Cleaner.
Flitecell is waterproof but it should remain dry where possible.
DO NOT submerge or shower.
Avoid placing Flitecell on the sand, which can make its way into the Flitecell
cavity and scratch surfaces.
DO NOT charge the Flitecell immediately after use. The Flitecell
temperature may be too high. Allow 30 minutes between riding and
charging to allow for cooling.
DO NOT clean the Flitecell or charger with denatured alcohol or other
flammable solvents.
IF THE BOARD HAS LEAKED AND / OR THE FLITECELL HAS BEEN SUBMERGED
IN WATER, INSPECT FOR WATER INGRESS USING THE SIGHT GLASS LOCATED
ON THE SIDE OF THE FLITECELL. STAND THE FLITECELL UP ON ITS BOTTOM
END FOR ONE MINUTE AND THEN PLACE THE FLITECELL ON ITS SIDE WITH
THE SIGHT GLASS FACING DOWN FOR ONE MINUTE. INSIDE THE SIGHT
GLASS IS A COLOUR CHANGING LABEL WHICH WILL TURN RED IF WATER IS
PRESENT. INSPECT THE SIGHT GLASS AND CONFIRM THAT WATER IS NOT
PRESENT BEFORE CHARGING AND USING A FLITECELL THAT HAS BEEN
IMMERSED IN WATER.
IF A FLITECELL HAS BEEN DROPPED OR DAMAGED, CONTACT FLITE
IMMEDIATELY AND DO NOT USE THE FLITECELL.
Regular maintenance
Examine the charger regularly for damage to the cord, plug, enclosure or
other parts.
Storage
Keep Flitecell stored out of the reach of children and pets.
DO NOT store the Flitecell near heat sources such as a furnace or heater.
DO NOT leave the Flitecell inside of a vehicle on hot days.
The ideal storage temperature is 10°C – 25°C.
Do NOT store the Flitecell whilst charging. Disconnect the charger when
not in use.
DO NOT store the Flitecell fully charged or discharged for a longer period
of time.
For long or short term storage a charge state of 40% (1 LED ON indicates
25 - 35% charge) is optimal. Only fully charge the Flitecell when planning
a ride. We recommend that you discharge the Flitecell during your final
session of the season and charge back up to the above state.
49
To Next Page
Loading...