Flite 3 Series - Page 48

eFoil system
Post ride
Disconnect the Flitecell power cables.
Rinse thoroughly with clean fresh water after every use.
Rinse the inside of the mast (through the notch in the rear of the flange)
with fresh water.
Rinse around the mast flange to wash salt away from the board connection
area (if keeping the board and eFoil attached).
Regular maintenance
Disassemble the eFoil from the board.
Remove the wing, fuselage cover and tail, and clean thoroughly with fresh
soapy water to remove any built-up salt or sand.
Storage
Always store the eFoil in a clean, dry environment.
Flite Controller and handlebars
Post ride
Remove the Flite Controller from the handlebars. Rinse the Flite Controller
and handlebars with fresh water to clean away salt and debris. Ensure a
steady stream of fresh water is applied directly into the trigger housing.
While doing so press and depress the trigger and thumb throttle numerous
times to loosen any sand, grit or debris that may aect its performance.
Peel out the rubber cover on the underside and clean this with fresh water.
Ensure this area is dry before replacing the cover.
Regular maintenance
Pre and post season, the 3 torque screws on the underside of Flite Controller
can be undone to release the trigger. This will allow you to thoroughly clean
and inspect the trigger, spring and magnet. Regularly check that the Flite
Controller trigger and handlebar throttle can move freely.
Storage
Store in a cool dry place, out of the sun.
48