Getting started
The best way to learn to Flitescooter is to find a Fliteschool in your area.
Locate your nearest Fliteschool at fliteboard.com/fliteschool
Watch the Flitescooter video guides at fliteboard.com/video
In order to operate the product correctly, avoiding damage or serious
injury, it is essential to read and follow all instructions and warnings in the
User Guide prior to assembly, setup or use.
FLITESCOOTER IS INTENDED FOR USE WITH THE SUPPLIED FLITE JET,
EFOIL AND WINGS ONLY. FLITESCOOTER IS INTENDED FOR USE WITH THE
SERIES 2.2 AND LATER FLITE CONTROLLER ONLY.
THE FLITESCOOTER EFOIL IS SET TO SCOOTER MODE AT FACTORY.
COVER
3. Avoid contact with the wings and Flite Jet
5
6
3
4
Flitescooter assembly
Inating Flitescooter
5. Keep distance
200m
6. Release the throttle
7. What’s in the box
Connect the handlebars to Flitescooter
Turn the handlebars upside down and place the Flite Controller wrist
strap over the bottom of the handlebars. Carefully slide the wrist
strap to the very top by holding onto Flite Controller.
With your other hand, lift the latch on the back of the Flite Controller
cavity. Place Flite Controller into the handlebar cavity and gently
push until you hear it click into place.
No relevant for scooter - image will be
removed
‘200m’ needs the right font
16
To Next Page
Loading...