Issue Troubleshooting guide
Flite Controller
shows 'Safety
Key Not Found'
Flitescooter needs the wireless safety key to operate.
Press the face of the wireless safety key to turn it on.
If 'Safety Key Detected' does not appear on Flite
Controller move away from other Flite Controllers
and wireless safety keys and try again. If this persists,
replace the coin cell battery within by strictly
adhering to the safety warning (page 9).
WIRELESS SAFETY KEY IS ONLY COMPATIBLE WITH
FLITESCOOTER.
Flite Controller
trigger not
functioning
To recalibrate the Flite Controller trigger, press and
hold the — (minus) and Mode (bottom) buttons
simultaneously. Follow the on-screen instructions.
Water in the
Flitescooter
cavity
Remove the board from the water.
Remove the Flitecell. Dry the board completely.
Check the Flitecell for leaks. If the Flitecell has
taken in water refer to the section below.
Once dried and re-assembled, take care that
the Flitescooter cavity seal is properly compressed
when closing the Flitescooter lid.
Water in
Flitecell
Flitecell has an indicator for water damage.
If water has penetrated the casing, regularly check
the circular water indicator on the side of your
Flitecell. If the sticker has turned red, this means
water has penetrated the housing.
IF WATER HAS PENETRATED THE FLITECELL,
PLEASE SET FLITECELL ASIDE IN A COOL
DRY PLACE. DO NOT ATTEMPT TO USE A
FLITECELL THAT HAS BEEN WATERLOGGED.
CONTACT FLITE IMMEDIATELY.
Unable to pair
Flite Controller
Please ensure no other controllers or boards are
switched on. Try again as per pairing instructions
(page 32).
Unable to pair
Flite Controllers
to multiple
boards
Do not attempt to pair multiple Flite Controllers
to multiple Flitescooters simultaneously.
Always pair one at a time.
Reduced
ride time
The battery management system (BMS) balances
and optimises the Flitecell during each charge cycle.
Allow 24 - 48 hours after charging before
Flitecell use.
51
To Next Page