4
CAUTION
Always use a manual screwdriver only; DO NOT use an impact driver for the screws at any times,
otherwise, it will void the warranty.
CAUTION
To reduce the risk of fire, connect only to a circuit provided with appropriate branch circuit overcurrent
protection (see TABLE 1) in accordance with the Canadian Electrical Code (CSA C22.1-12) and the
National Electrical Code (ANSI/NFPA 70).
1 Handle packing with care. Always use safety glasses and gloves when unpacking and installing.
2 Communicate with a certified contractor, certified electrician, or trained installer to ensure compliance with local
building code, regulation, security standards and weather conditions.
3 Verify with local authorities that the location where the EVSE is to be installed is free from underground pipelines
or electrical equipment, otherwise you might inflict yourself serious injuries.
4 This EVSE is designed to be wall-mounted or post-mounted.
5 If installed on a wall mount configuration do not install on or over a combustible surface.
6 Make sure that the types of mounting surface of the wall or the post be strong enough to bear a minimum of
125 pounds (56.7 Kg.) per anchoring point in the vertical and horizontal direction, and that anchors be compatible
with the type of mounting surface.
7 This product must be connected to a grounded, metal, permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lead
on the product and installed by a certified electrician.
8 Any EVSE part alteration will automatically void the warranty.
CoRe+ Max
TM
Installation Manual
To Next Page
Loading...
