Floe VSD 8000 - Page 8

8
STEP 2
FIGURE
2.10
FIGURE
2.9
 IMPORTANT NOTE: HOLES IN BALL SCREW, BALL
SCREW CLAMP, AND BEARING BLOCK MUST BE
ALINGNED BEFORE INSERTING BOLTS.
(FIGURE 2.9)
 ATTACH BALL SCREW TO BALL SCREW CLAMP USING (1) 3/8 x 6” BOLT,
(1) ½ x 6” BOLT, (1) 3/8 NYLOCK NUT, AND (1) ½ NYLOCK NUT (FIGURE
2.10).
 IMPORTANT NOTE: BOLTS MUST BE INSERTED INTO THE
BALL SCREW AND BEARING BLOCK (FIGURE 2.11).
TORQUE 3/8” NUT TO 35 FT-LBS AND ½” NUT TO 80 FT-LBS (FIGURE
2.12).
FIGURE
2.11
FIGURE
2.12
FIGURE
2.10