How to fix a Flotec (FP7100 that starts and stops?
The motor may be overheating. This can happen if the discharge or intake are obstructed or if the pump is in water that is too shallow. Check these potential causes and correct them.
What to do if my Flotec Water Pump won't start or run?
If your Flotec Water Pump won't start or run, here are a few things to check: * First, ensure the pump is properly plugged into a working outlet. * Next, inspect the fuse or breaker. If it's blown, replace the fuse with one of the correct size or reset the breaker. * Also, low line voltage can be a factor. If the voltage is below the recommended minimum, examine the wiring size from the main switch. If the wiring is adequate, contact your power company or hydro authority. * If none of these steps work, the motor may be defective, requiring pump replacement.
What to do if my Flotec Water Pump delivers little or no water?
Several issues could be the cause. There might be a restricted discharge due to an obstacle or ice in the piping, in which case you should remove the pump and clean both the pump and the piping. Alternatively, there could be a restricted intake; remove the pump and clean out the intake screen. Low line voltage can also cause this problem; check the wiring size from the main switch on your property. If the wiring is okay, contact your power company or hydro authority. A worn or plugged impeller can also be the culprit, requiring you to replace the pump. Finally, the anti-airlock hole might be plugged. In that case, turn off the pump, clean out the anti-airlock hole, and then restart the pump.
Why won’t my Flotec (FP7100 start?
First, check if the pump is properly plugged into an outlet. If the fuse is blown, replace it with a fuse of the correct size, or reset the breaker. If the voltage is below the recommended minimum, inspect the wiring size from the main switch on your property. If the wiring is adequate, contact your power company or hydro authority. As a last resort, you might need to replace the pump.
What to do if Flotec Water Pump discharge from faucets is air or milky?
If the water discharging from your faucets appears milky or contains air when using a Flotec Water Pump, it could be due to gas present in the well water. To address this, remove the bleeder orifices and plug the tees, ensuring that these plugs are completely sealed to prevent leaks. Another potential cause is a malfunctioning air volume control. If this is the case, replace the control as needed.
Why does my Flotec Water Pump operate but delivers little or no water?
If your Flotec Water Pump is running but not delivering enough water, consider these possibilities: * There might be a restriction in the discharge, such as an obstacle or ice in the piping. In this case, remove the pump and clean both the pump and the piping. * A restricted intake can also cause this problem. Remove the pump and clean out the intake screen. * Low line voltage could be the issue. If the voltage is under the recommended minimum, check the wiring size from the main switch on your property. If the wiring is okay, contact your power company or hydro authority. * A worn or plugged impeller can also reduce water delivery, requiring pump replacement. * Finally, a plugged anti-airlock hole might be the cause. Turn off the pump, clean out the anti-airlock hole, and then ...
Why is my Flotec Water Pump delivering little or no water?
General| Series | FP7100 |
|---|---|
| Voltage | 115 V |
| Impeller Material | Thermoplastic |
| Switch Type | Automatic |
| Thermal Protection | Yes |
| Maximum Flow Rate | 33 GPM |
| Max Flow Rate | 33 GPM |
| Maximum Head | 25 ft |
| Max Head | 25 ft |
To Next Page
