How to fix a Flotec FPSE9000 Water Pump that will not shut off?
If your Flotec Water Pump will not shut off, examine the switch or controller automatic floats to ensure they are operating correctly and are properly positioned. Refer to the installation instructions for your specific switch/controller for guidance.
What to do if my Flotec Water Pump fails to operate?
If your Flotec Water Pump isn't working, first ensure the power cord is securely plugged into the outlet. Disconnect power before handling the pump or motor. Also, verify that you have electrical power and that the liquid level is high enough to activate the switch or controller. Check the 3/16” (4.7 mm) vent hole in the discharge pipe to make sure it's not blocked, and inspect the pump inlet, impeller, check valve, and discharge pipe for any blockages. If the thermal overload has tripped, test start the pump; if it starts and stops immediately, disconnect it from the power source for 30 minutes to allow the motor to cool, then reconnect. Also, check for the cause of overheating/overloading.
What to do if my Flotec Water Pump fails to empty sump?
If your Flotec Water Pump isn't emptying the sump, ensure all valves in the discharge pipe are fully open. Clean out the discharge pipe and check valve. Also, inspect the pump inlet and impeller for any blockages. If the pump is not sized properly, a higher capacity pump may be required.
Why is my Flotec FPSE9000 Water Pump failing to empty the sump?
If your Flotec Water Pump won't empty the sump, ensure all valves in the discharge pipe are fully open. Clear any blockages from the discharge pipe and check valve, and inspect the pump inlet and impeller for obstructions. It's also possible that the pump isn't adequately sized for the job, and a higher capacity pump might be necessary.
Why won't my Flotec FPSE9000 Water Pump shut off?
If your Flotec Water Pump won't turn off, check the switch or controller automatic floats for proper operation and location.
Guides users to the English language sections covering installation, operation, and parts.
Emphasizes the importance of reading and following all safety warnings and instructions provided.
Details the performance specifications of the pump, including GPH at different feet of head.
Provides essential guidelines for installing the pump, including surface requirements and piping.
Highlights hazardous voltage warnings and safe electrical connection practices for the pump.
Provides advice on pump operation, including dry running prevention and overload protection.
Lists common repair parts for the pump, such as power cord, float switch, and impeller.
Diagnose and resolve common issues like pump failure to operate or empty sump.
Critical safety warning regarding lifting the pump by its power cord.
Details the twelve (12) month limited warranty and specific product exceptions.
Outlines the general terms, conditions, and limitations of the product warranty.
General| Brand | Flotec |
|---|---|
| Model | FPSE9000 |
| Category | Water Pump |
| Language | English |
To Next Page
