Adapta Valve Installation
Turn off cold water supply to the kitchen faucet by turning the angle stop valve clockwise.
Reverse Osmosis Module Mounting
Determine best location for the RO module to be mounted to allow
for future system maintenance. The parts bag has 2 self tapping
screws. Using a phillips screwdriver, screw them into the cabinet
wall 6 ” apart and at least 16” from the bottom of the cabinet.
Step 11
Step 12 Attach adapta valve as illustrated in the three photos above, choosing the
confi guration that fi ts your plumbing. The green tube from inlet side of RO
module will be cut to length and attached later in the installation.
Water supply line to the system must be from the cold water supply line. Hot water
will severely damage the system.
To Next Page
Loading...