3.2 Unpacking
■ The materials (cardboard) used for packing the appliance are fully recyclable.
■ It is recommended that the packing material is only removed prior to installing the water heater. The
manufacturer will not be held responsible for damage caused by incorrect storage of the product.
■ Packing materials (plastic bags, polystyrene, nails, etc.) must not be left within reach of children, in that
these items represent a potential hazard.
A. Place the packed appliance on the floor
(see fig. 1) making sure that the "up” arrow
is facing down. Remove the staples and
open out the four flaps of the box.
B. Rotate the water heater 90° while
manually supporting it from underneath
C. Lift the box and remove the protections.
Lift the water heater by grasping the rear
part and proceed with the installation.
STORAGE & HANDLING
Please note that prior to installation the
Radiant water heaters should be stored in
the horizontal position with no more than
three water heaters to a stack;
Ensure that the water heaters are stored in
dry conditions and be aware that the carton
is a tow-man lift;
To Next Page
Loading...