Copyright Reserved, DONGYANG Corporation 13
7.0 TROUBLESHOOTING
Symptom Probable Cause Solution
1. Parameter wrong
Check the parameters (Transmitter,
K-factor and size)
Measurement is not
accurate
2. Pipe is not fully filled Check if meter is fully filled
1. Grounding issue
Make sure meter is properly
grounded to a good earth ground
2. Air
Make sure fluid does not contain air
bubbles
Flow rate indication
is unstable
3. Converter location – outside
electrical interference
Make sure Converter is not too
close to sources of electrical
interference
1. No power Apply correct power
2. Incorrect power Check power value
3. Wiring connections
Check power input/output
connections
No Display
4. Fuse blown Replace fuse
To Next Page
Loading...