What to do if my Flowmeter Measuring Instruments has no display?
If the Flowmeter Measuring Instrument shows no display, first ensure that the correct power is applied and that the power value is correct. Next, check the power input/output connections and replace the fuse if it's blown.
Why is the flow rate indication unstable on my Flowmeter LDG?
If the flow rate indication on your Flowmeter Measuring Instrument is unstable, ensure the meter is properly grounded to a good earth ground. Also, check that the fluid does not contain air bubbles and that the converter is not too close to sources of electrical interference.
How to troubleshoot inaccurate measurements in Flowmeter LDG?
If the measurement on your Flowmeter Measuring Instruments is not accurate, check the parameters, including the transmitter, K-factor, and size. Also, make sure the pipe is fully filled.
Examine meter for visible damage, remove protective plugs, and inspect for missing items.
Guidelines for lifting and handling the detector and meter to prevent damage.
Ensuring pipes are filled, avoiding air bubbles, pulsating flow, and electrical interference.
Guidelines for inlet and outlet straight pipe runs for optimum accuracy.
Details on flange standards, gasket use, and bolt tightening for secure connections.
Provides drawings and tables for detailed physical dimensions of the flow meter.
Diagram and table detailing the meter's terminal connections for power and output signals.
General| Type | Electromagnetic Flowmeter |
|---|---|
| Measurement Principle | Faraday's Law of Electromagnetic Induction |
| Accuracy | ±0.5% of reading |
| Conductivity | ≥5 μS/cm |
| Power Supply | 24 VDC |
| Output Signal | 4-20 mA, Pulse |
| Protection Class | IP67 |
| Lining Material | PTFE |
| Electrode Material | Hastelloy C, Titanium |
| Flow Rate Range | 0.1 to 12 m/s |
| Material | Stainless Steel, Carbon Steel |
To Next Page