FLOWTECH flowpress WMDA - Controller Programming

Controller Programming
Do not alter any seings without first understanding the implications of doing so. Incorrect seings may cause
damage to the equipment, system or property.
To enter the programming menu, hold the (+) buon until “enter code” appears on the screen, followed by
“0000” with a flashing cursor aer the first digit.
To gain access to the programming menu, one of the following codes must be entered:
Customer Code Standard set of options 2601
To enter the code, change the first digit with the (+) and (-) buons, then press (SET) to move onto the
next digit. Repeat for all digits, then once the correct code is shown on the display, press (SET) to enter the
programming menu.
Once a correct code has been entered, the first option [COLD FILL] will appear on the screen.
Once in the menu, the value of the current menu item can be changed using the (+) and (-) buons. Once
the current value has been set, pressing the (SET) buon will move on to the next option.
It is not possible to navigate backwards through the menu. To return to a previous seing in the menu, press
the (SET) buon repeatedly to scroll through to the end of the menu, and then re-enter the appropriate code.
If the controller looses power while in the programming menu, all changes made will be erased. To confirm all
changes, the end of the menu must be reached, and the “SAVING...” message must be displayed.
16